Skip to main content
Fig. 8 | 3D Printing in Medicine

Fig. 8

From: DICOM segmentation and STL creation for 3D printing: a process and software package comparison for osseous anatomy

Fig. 8

Comparison of STL models between S3D (a) and MIT (b), where the shape error between the two STL models was the minimum value. Visualization of the shape error (signed differences) after superimposition is shown on the right (c). Almost all of the STL model was green. The mean error between the two STL models was 0.00 mm (maximum + 0.16 mm, minimum − 0.17 mm)

Back to article page

3D Printing in Medicine

ISSN: 2365-6271

Contact us