Your privacy, your choice

We use essential cookies to make sure the site can function. We also use optional cookies for advertising, personalisation of content, usage analysis, and social media, as well as to allow video information to be shared for both marketing, analytics and editorial purposes.

By accepting optional cookies, you consent to the processing of your personal data - including transfers to third parties. Some third parties are outside of the European Economic Area, with varying standards of data protection.

See our privacy policy for more information on the use of your personal data.

for further information and to change your choices.
Skip to main content
BMC is moving to Springer Nature Link. Visit this journal in its new home.
Fig. 1 | 3D Printing in Medicine

Fig. 1

From: Measured and simulated mechanical properties of additively manufactured matrix-inclusion multimaterials fabricated by material jetting

Fig. 1

Left: Drawing of the specimen with inclusions. During the measurements, it was loaded in X-direction. A layer from the center was cut out and used for simulation as shown on the right side. Right: Render of the simulated layer with \(10\times 4\) inclusions. The bottom side is fixated in X direction and the upper surface is displaced to reach a strain of \(\varepsilon =0.25\%\)

Back to article page

3D Printing in Medicine

ISSN: 2365-6271

Contact us