Skip to main content
Fig. 2 | 3D Printing in Medicine

Fig. 2

From: Accuracy of pelvic bone segmentation for 3d printing: a study of segmentation accuracy based on anatomic landmarks to evaluate the influence of the observer

Fig. 2

Visualization of DICOM (blue boxes, left) and STL (red boxes, right) landmark measurements. LM1: Longest distance between the iliac crests, LM2: Angle between the anterior surface of the fifth lumbar vertebra (L5) and the anterior surface of the first sacral vertebra (S1), LM3: Distance between the anterior superior iliac spines, LM4: Distance between the upper edge of the symphysis and the promontory, LM5: Distance between the lower edge of the symphysis and the promontory, LM6: Distance between the lower edge of the symphysis and the tip of the coccyx, LM7: Distance between the ischial tuberosities, further information about the orientation of the measurement planes can be found in Fig. 10 of the Appendix

Back to article page

3D Printing in Medicine

ISSN: 2365-6271

Contact us