Your privacy, your choice

We use essential cookies to make sure the site can function. We also use optional cookies for advertising, personalisation of content, usage analysis, and social media.

By accepting optional cookies, you consent to the processing of your personal data - including transfers to third parties. Some third parties are outside of the European Economic Area, with varying standards of data protection.

See our privacy policy for more information on the use of your personal data.

for further information and to change your choices.
Skip to main content
Fig. 18 | 3D Printing in Medicine

Fig. 18

From: Insights into geometric deviations of medical 3d-printing: a phantom study utilizing error propagation analysis

Fig. 18

PrE analysis of the Replicator 2X prints. Two outliers are highlighted with red boxes. The heat maps indicate the deviation between construction STLs and 3D-scans of printed models according to the legend on the right. The heat maps are arranged according to the print bed orientation of the corresponding printed models. For each of the five printed models, a view from above and a view from below are presented. In particular, the heat maps corre-sponding to the two outliers from the plots in Figure 10 clearly show that more severe warping has occurred

Back to article page

3D Printing in Medicine

ISSN: 2365-6271

Contact us